My CHD18x2 does not output two separate HD-SDI signals (left and right eye) when I ingest a 3D HDMI signal. : LYNX Technik AG - Technical Support

Knowledge base

Welcome to LYNX Technik AG Technical Support. Below you will find our Knowledge Base. You can either browse for an article by reviewing the topic headings, or you can search the Knowledge Base by entering a search term (for example “PVD 5840 AV Delay”….). If you are a registered user and currently logged into the system then you can also search your support tickets in the same way. If the Knowledge Base does not provide the answers you require, then please open a new ticket to submit your specific questions.

My CHD18x2 does not output two separate HD-SDI signals (left and right eye) when I ingest a 3D HDMI signal. Print

Modified on: Fri, 28 Mar, 2014 at 12:06 PM

The CHD18x2 supports 3D signals, but it does not separate left eye and right eye and outputs it on the two SDI outputs.

The reason is, that the second SDI output is looped from the first output and carries the same signal.

A 3D HDMI signal (e.g. Frame Packed 3D) is converted into a SDI 3G Level-B Dual Stream Signal.
I.e. the left eye information and the right eye information are mapped as two HD-SDI streams and combined into one physical 3G-SDI signal.
It is not possible to choose into which stream which eye is embedded.

The specific standard of the outputed 3G-Signal is:
SMPTE 425M Level B – Mapping of 2 x SMPTE 292 HD-SDI Interfaces into a SMPTE 424M 3G-SDI interface.

Did you find it helpful? Yes No

Knowledge base

My CHD18x2 does not output two separate HD-SDI signals (left and right eye) when I ingest a 3D HDMI signal. Print

Related Articles