VITC transmition using OTX 1712/ ORX1702 : LYNX Technik AG - Technical Support

Knowledge base

Welcome to LYNX Technik AG Technical Support. Below you will find our Knowledge Base. You can either browse for an article by reviewing the topic headings, or you can search the Knowledge Base by entering a search term (for example “PVD 5840 AV Delay”….). If you are a registered user and currently logged into the system then you can also search your support tickets in the same way. If the Knowledge Base does not provide the answers you require, then please open a new ticket to submit your specific questions.

VITC transmition using OTX 1712/ ORX1702 Print

Modified on: Thu, 29 Apr, 2021 at 4:30 PM

Some detail information about OTX1712/ORX1702

The Analog sync modules have two modes,

1. Sync mode - used for analog sync only

2. Video mode used for SDTV composite video content

The OTX 1712 A/D converter is the sending device - which basically takes the analog signal (sync or video) and converts it to SDI to beam out over fiber...

The ORX 1702 is basically a SDI fiber receiver, with a D/A converter inside.

As analog VITC is considered part of the video signal rather than sync - to send video as opposed to sync requires changing the transmitter to send analog video signal, this is done by connecting up the modules to a PC and using yelloGUI software to change settings, one has to change the settings in the transmitter and receiver end. If one of them is set to SDTV Video Content" = OFF, It will strip off any Video content. So in Analog Sync Mode, it will not transmit transparently.

Setting the SDTV Video content to ON, the VITC at is transmitted and receive.

Did you find it helpful? Yes No

Knowledge base

VITC transmition using OTX 1712/ ORX1702 Print

Related Articles